Brake Equipment

HP Race brake bleed valve

HP4 (ECE / USA)

Product description

  • Patented system for brake filling and bleeding.
  • Fast, straightforward, reliable and completely leaktight.
  • Integrated non-return valve for one-man operation.

Details

  • Patented system for brake filling and bleeding: quick, easy, clean and reliable.
  • Brake-fluid changes are easy, completely reliable, a simple step-by-step procedure.
  • Brake bleeding in a matter of minutes, no helper's assistance required.
  • Brake-bleeding system used successfully in motorsport and in aeronautics.
  • Total leaktightness preserved throughout the entire procedure of filling and bleeding the brake system.
  • The bleed valve consists of 2 parts with non-return function. In the process of filling and bleeding the brake, only the top part of the valve is backed off. There is an O-ring integrated into this part of the valve.
  • Air cannot make its way via the thread into the brake system while brake bleeding is in progress (the seal at the thread is preserved).
  • 100 % braking performance by avoidance of air in the brake system.
  • Does away with the risk of brake fluid escaping in the brake bleeding procedure and damaging the surface of the brake caliper or painted parts of the motorcycle.
  • Integrated non-return valve for one-man operation.
  • Dispenses with the fault-prone step of synchronised opening and closing of conventional bleed screws.
  • A drop in pressure causes the bleed valve to close automatically and remain closed until the next bleed pressure surge.
  • Less wear and tear on the tapped bore in the brake caliper: The repeated opening and closing of conventional bleed screws in the brake-bleeding process puts severe strain on the tapped bore in the aluminium brake caliper.
  • The larger longitudinal bore is less prone to the formation of deposits or dirt than the conventional small transverse bore.
  • Long service life.
  • Easy conversion: The HP Race brake bleeding valve takes the place of the standard bleed screw in the brake cylinder.
  • Scope of supply: 2 bleed valves for the front brake, 1 bleed valve for the rear brake, installation instructions and instructions for use.
  • Homologated for use on public roads.

Recommended in combination with:

  • HP Race brake bleed gaiter (preliminary available from February 2013)
  • HP Race brake lever with remote adjuster

Order information

Designation: HP Race brake bleed valve HP4
Part number: 77 02 8 536 257